The Navigator Stove Forum


Search For Similar Forums   ·   Return to Website

  First
  Prev
  Reply
  Forum
Next  
Last  
Search this Forum:  
Viewing Page 1 of 1 (Total Posts: 2)


Author Comment    
NSW for Barry Maynard

marinest@marinestove.com


Nov 7, 07 - 10:11 PM
Very Long Burn Times

Good Morning……I just wanted to get back to you on the operation of the Little Cod we installed on Jonathan (Heritage 46 center cockpit sailboat). The installation went as advertised and the comments we get from all that see it have been encouraging to us that we did the right thing by installing it. There is however a particular problem we would like to bring to your attention…….we have a interesting dilemma in that we cannon keep the inside of the boat under 75 degrees when we fire it up, regardless of the temperature outside . All kidding aside this is the solution we have needed for adequate simple heating aboard Jonathan.

The fuel that we use comes from Daville Supply a feed store north of Seattle. The logs look like a traditional presto log but are compressed much tighter and weigh in at 8 lbs. They are called (North Idaho Energy Logs. One log gives sufficient heat for 6 to 7 hours. There is no smoke no creosote and very little ash left over.

Thanks again for a great product.



Barry Maynard

S/V Jonathan
Scott aboard S/V Baggy Wrinkle

www.bmi.net/bowlerws


May 2nd, 2008 - 1:46 AM
Re: Very Long Burn Times

Hello Barry!

Those "Idaho" logs that you're burning are full of different chemicles including wax. Even if you damper the stove down, the wax will still cause the wood chips and sawdust that the "logs" are made of to burn dangeriously hot. I have found that if I take my little hatchet and cut the "logs" into around 8, 2" disks, place them on one page of newspaper with some charcoal lighter, they will even get wet wood going. My burn of choice is alder. It will burn even when its green. Cedar burns too hot. Hemlock is really wet unless it's seriously seasoned and will stop burning. I do get creasote with the alder, but just pull the Charlie Noble off and take a length of anchor chain and rattle it down until the pipe is clean. That takes but just a minute while the stove is out.

It would be my suggestion to use only real wood for the actual heating. A small pack frame, a hatchet, and one of those neet Japanese folding pruning saws and you can collect enough wood in a day to last all week. You can even ride the bus with this rig and who is going to say anything? It's nice to get off the boat and foray into the wild. I can get anywhere I want to go in Clallam county on the local bus for $2 a day all day long! Cruising in the NW, one can row ashore and usually fill up a dingy with feed sacks full of wood. A dingy full will last weeks.

I had to leave the butterfly hatches open before I got all this figured out, so I hope the info helps out. I don't know a boater that can consistantly find "seasoned" hardwood every time out. We have to go with what we've got. In the city, the power company may be able to give you a lead on where to scavenge branches. Bon Chance!

Your friend,

WSB
S/V Baggy Wrinkle


  First
  Prev
  Reply
  Forum
Next  
Last  




Get your own FREE Forum today! 
Counters & Site Stats   Online Photo Albums   Free Blogs   Free Web Hosting  powered by Powered by Bravenet bravenet.com